Ryobi AP4700 Manuel D'utilisation page 8

Protect battery contact to avoid a short circuit caused by metallic object that can cause a fire or
■
explosion!
Do not rivet or screw any name-plates or signs onto the device. The protective insulation can thereby
■
be rendered ineffective. Adhesive labels are recommended.
Only charge original recommended batteries.
■
If the power cord is damaged, it must be replaced by an Authorised Service Center in order to avoid a
■
hazard.
WARNING
Do not recharge primary cells (non-rechargeable).
Damage to property/material
Mains voltage must corresp ains voltage must correspond with the voltage specifications on the
device.
ASSEMBLY
No assembly required on this product.
DESCRIPTION
1. Battery Pack (not included)
3. LEDs
SPECIFICATIONS
Battery Pack Voltage
AP4001 4 V
2. Charger
4. Power Socket
Charger Input
220V-240V, 50Hz-60Hz AC only
2
Battery Capacity
1500 mAh