Cleaning - SilverCrest SWKP 3100 A1 Mode D'emploi

3. Fill the kettle 2 with fresh drinking water -
minimum 0.5 litres, maximum 1.7 litres.
Keep it upright or place it on an even sur-
face to be able to read the water level
display 3 correctly.
4. Close the lid 10, by pressing it down-
wards.
5. Place the kettle on the device base 5.
6. Insert the mains plug 6 into a readily
accessible earthed wall socket whose
voltage matches the voltage stated on
the rating plate.
7. Press the on/off switch
it lights up and locks into place.
8. The device automatically switches off as
soon as the water starts to boil, or when
you remove the kettle 2 from the device
base 5.
9. Disconnect the mains plug 6 from the
wall socket.
10.Remove the kettle 2 from the device
base 5 and pour the water out.
NOTE: to interrupt the cooking process,
press the on/off switch
7 down, until
7 up.

8. Cleaning

DANGER! Risk of electric
shock!
Pull the mains plug 6 out of the wall
socket before you clean the kettle 2.
The kettle 2, the device base 5, the pow-
er cable and the mains plug 6 must not
be immersed in water or other liquids.
DANGER! Risk of injury
through scalding!
The kettle 2 becomes very hot during op-
eration. Allow it to cool down before
cleaning.
WARNING! Risk of material damage!
Do not use any astringent or abrasive
cleaning agents.
Cleaning the kettle
1. Disconnect the mains plug 6 from the
wall socket.
2. Wipe the kettle 2, the device base 5
and the power cable 6 with a damp
cloth if necessary. Dry with a dry cloth.
3. Allow all parts to dry completely before
you put them away or use the device
again.
Cleaning the limescale filter
1. Open the lid 10.
2. Pull the limescale filter 1 off upwards
from the kettle 2.
3. Clean the limescale filter 1 with a moist
dishcloth under running water.
4. Slot the limescale filter 1 into the intend-
ed fitting in the kettle 2 and press it
downwards.
7
GB