Cleaning And Care; In The Event Of Scale Deposits; Removing/Replacing The Pouring Sieve; Storage - SilverCrest SWK 3000 EDS A1 Mode D'emploi

Cleaning and Care

Danger
Do not open any part of the housing.
There are no user-servicable elements inside.
An open housing can create the risk of a lethal
electrical shock.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered com-
ponents.
Risk of personal injuries
Before cleaning the appliance, remove the plug
from the mains power socket and allow the appliance
to cool down.
• Clean the exterior surfaces and the power cord
with a slighly damp cloth. Be sure to dry the ap-
pliance well before taking it back into use.
• For stainless steel surfaces, you can use appropri-
ate cleaning agents from a specialized dealer.
• Never use detergents, abrasive cleaners or sol-
vents. These can damage the appliance.

In the event of scale deposits:

• Before descaling, remove the pourer sieve 5
(see chapter "Removing/replacing the pourer
sieve").
• Obtain any decalcifying agent suitable for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a hardware shop. Proceed as detailed in
the instructions provided for the use of the de-
calcfying agent.

Removing/replacing the pouring sieve

• Open the lid.
• Press the retainer at the top of the pourer sieve 5
down and, at the same time, pull the pourer sie-
ve 5 inwards.
• Remove the pourer sieve 5.
• Clean the pouring sieve 5 with a lightly
moistened dishcloth and under running water.
• Replace the pourer sieve 5 after cleaning it.
Ensure that the retainer engages and that the
pourer sieve 5 is firmly seated.
Notice
Should the scale deposits in the pourer sieve 5 be
firmly established, lay it in a water-vinegar solution
having a ratio of 6:1 for a few hours. The scale de-
posits will dissolve themselves. Rinse the pourer sie-
ve 5 with lots of clear water.

Storage

Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable around the cable retainer on
the underside of the base 3.
• Store the appliance in a dry place.
- 22 -