Ugolini CADDY Carnet D'instructions page 12

CADDY
ambient temperature and beverage initial
temperature.
2
To shorten product cooling down time and
increase productivity, it is advisable to pre-chill
the product to be used in the dispenser.
3
To shorten product cooling down time and
increase productivity, the bowl should be refilled
after the product level drops lower than half and
at the start of each day.
4
The dispenser must be able to emit heat.
In case it seems excessive, check that no
heating source is close to the unit and air flow
through the slotted panels is not obstructed by
wall or boxes. Allow at least 15 cm (6") of free
clearance all around the dispenser.
In any case if the product in the bowls is cold the
unit is running properly.
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are
recommended to guarantee the conservation
of the best product taste and the highest unit
efficiency. This section is a procedural
g u i d e l i n e o n l y a n d i s s u b j e c t t o t h e
requirements of the local Health Authorities.
Prior to the disassembly and cleaning, the
machine must be emptied of product.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source by
unplugging it or switching off the 2-pole
wall breaker.
1
Remove cover from the bowl.
2
Uncouple (1) the pump cover retainer and lift
it up and out (2) (see figure 1).
3
Remove the pump cover.
4
Remove the empty bowl by lifting first its rear
side (opposite to faucet side) up and off bowl
gasket (see figure 2).
5
Remove the bowl gasket.
6
Remove the pump impeller from its location.
7
Pinch tube faucet: push the dispensing
handle (1) and take the pinch tube off from its
12
figure 1
figure 2