Ugolini CADDY Carnet D'instructions page 11

PROCEDURES).
IMPORTANT
Install the dispenser so that the plug is
easily accessible.
4 TO OPERATE SAFELY
1
Do not operate the dispenser without
reading this operator's manual.
2
Do not operate the dispenser unless it is
properly grounded.
3
Do not use extension cords to connect the
dispenser.
4
Do not operate the dispenser unless all
panels are restrained with screws.
5
Do not obstruct air intake and discharge
openings: 15 cm (6") minimum air space all
around the dispenser.
6
Do not put objects or fingers in panels
louvers and faucet outlet.
7
Do not remove bowls, augers and mixers for
cleaning or routine maintenance unless the
dispenser is disconnected from its power source.
ATTENTION
In case of damages, the power cord must
be replaced by qualified personnel only in
order to prevent any shock hazard.
5 OPERATING PROCEDURES
1
Clean and sanitize the unit according to the
instructions in this manual. See chapter 5.3
CLEANING AND SANITIZING PROCEDURES.
2
Fill the bowls with product to the maximum
level mark. Do not overfill.
The exact quantity of product (expressed as
liters and gallons) is shown by marks on the
bowl.
3
In case of products to be diluted with water,
pour water into bowl first, then add correct
quantity of product. In case of natural squashes,
it is advisable to strain them, in order to prevent
pulps from obstructing the faucet outlet.
4
Install the covers and check that they are
correctly placed over the bowls.
5
Set the control switches as shown in chapter
5.1 DESCRIPTION OF CONTROLS.
6
The dispenser must always run with the
c o v e r s i n s t a l l e d t o p r e v e n t a p o s s i b l e
contamination of the product.
7
Always leave the dispenser on, as the
refrigeration stops automatically when the
beverage reaches the dispensing temperature.
The mixing devices will continue to turn.
8
To maintain a high standard of flavour, keep
refrigeration and mixing devices on during the
night when beverage is in the bowl.
IMPORTANT
Operate the dispenser with food products
only.
5. 1 DESCRIPTION OF CONTROLS
The dispenser is equipped with the power
switch only. When it is set to position I, the
power is turned on both to mixing devices and
to refregeration.
IMPORTANT
Should despenser be operated without
using all the bowls (left bowl, facing the
unit from dispensing side, must be always
used) it is advisable to remove (see 5.3.1
DISASSEMBLY
impeller from the empty bowls.
If operated without liquid, the impeller
would be seriously damaged.
Beverage temperature adjustment (models 7/
1 and 10/1 only): turn the knob, located on the
right of the faucet side of the dispenser,
toward right to decrease temperature or
vicevarsa.
5. 2 HELPFUL HINTS
1
The length of time for cooling down the
product is governed by many variables, such as
11
paragraph) the pump