D-Link AC1200 Guide D'installation Rapide page 19

2. What can I do if I forgot my password?
If you forgot your password, you must reset the DAP-1665. Unfortunately
this process will change all your settings back to the factory defaults.
To reset the access point, locate the reset button (hole) on the rear
panel of the unit. With the access point powered on, use a paper clip
to hold the button down for 10 seconds. Release the button and the
access point will go through its reboot process. Wait about 30 seconds
to access the access point. When logging in, the username is Admin
and leave the password field empty.
3. How do I add a new wireless client or PC if I have forgotten my
wireless network name (SSID) or wireless encryption key?
• If you have not changed your Wi-Fi settings from the factory
defaults, you can use the information from the provided Wi-Fi
Configuration card to connect to the router or access point.
• If you have changed your Wi-Fi settings, you should access the web-
based configuration utility as described on page 14, and complete
the Setup Wizard again.
• Make sure you write down the settings displayed at the end of
the Setup Wizard, so that you can enter them into each wirelessly
connected device.
DAP-1665 Install Guide
19