D-Link AC1200 Guide D'installation Rapide page 14

Connect one Ethernet-based device, such as a computer, video game console, Network Attached
4
Storage (NAS) device, or media player to your existing wireless network.
After powering on your DAP-1665 as shown on the previous page, attach one end of the included
1
Ethernet cable to the LAN port on the back of the DAP-1665 and the other end into the Ethernet
port on your wireless router.
From the computer connected to your wireless router, open a web browser (e.g., Internet
2
Explorer, Firefox, Safari, or Chrome). Enter http://dlinkap.local./. If you have more than one
access point, enter http://dlinkapxxxx.local. (where xxxx represents the last four digits of the
access point's MAC address, which is located on the label on the bottom of the device). Use the
Setup Wizard to configure your AP manually. (See instructions on the next page).
* The default IP address is 192.168.0.50. Once the DAP-1665 (in Repeater or Client mode) connects to your
router, it will get assigned a new IP address based on your router/network's DHCP settings. You will need
to log in to your router and view the DHCP table to see what IP address was assigned to the DAP-1665.
The MAC address is printed on the label on the bottom of the device.
14
Configure Using a Web Browser
RESET
LAN
5V 1A
RESET
LAN LAN
5V 1A
or
or
USB
WPS
1
2
LAN
3
4
INTERNET
POWER
12V 2A
DAP-1665 Install Guide