D-Link AC1200 Guide D'installation Rapide page 13

Wireless Client Mode
Plug the supplied power adapter into your DAP-1665 and connect it to the outlet or to a surge
1
protector. Press the Power switch on the back of the device. Verify that the Power LED is lit.
Press the WPS button on your existing wireless router or AP.
2
Note: Usually the WPS LED will start to blink. If necessary, check your router's user manual for more
information.
Within one minute, press and hold the WPS button on the DAP-1665 for about one second. The
3
WPS LED will blink. When the Security LED becomes a solid green, it means wireless security
is enabled.
DAP-1665 Install Guide
Installation
WPS Button
RESET
LAN
5V 1A
13