Dispensing With The Steam Wand; Dispensing Hot Water; Programming; Coffee Doses - Wega EVDS io Mode D'emploi

6.11 Dispensing with the steam wand

• Immerse the steam nozzle in the
liquid to be heated;
• Rotate the valve knob anticlock-
wise;
• The quantity of steam will be pro-
portional to how much the valve
is open;
• To stop dispensing, turn the valve's
knob clockwise.

6.12 Dispensing hot water

• Place the pot
under the hot
2
(6)
water spout ;
• turn the water
knob counter-
(2)
clockwise ;
• t o i n t e r r u p t
6
steam dispens-
ing turn the wa-
ter knob clock-
(2)
wise .
Avoid contact with the hot water nozzle, do not place your hands
or other body parts near the hot water nozzle tips.
User manual
7

PROGRAMMING

The machine is programmed by default. Should the
settings need to be modified, proceed as described in
the following paragraphs.

7.1 Coffee doses

6
• Always programme the right
push-button panel first. This
way, both push-button panels
are automatically programmed.
If necessary, programme the
left later;
• place the cup under the dis-
pensing spout;
• press the STOP/PROG. button
for at least 5 seconds until the
STOP/PROG. button flashes;
• press the desired dose button,
for example
• to confirm the dose, press the
button again ;
• repeat this operation for the
other dose buttons;
• when the programming is com-
plete, press the STOP/PROG.
button until all of the LEDs on
the push-button panel are lit.
The programming of every dose must be carried out with ground
coffee and not with previously used coffee dregs.
The system automatically exits the programming mode 20 seconds
after the last operation was carried out.
Do not remove the filter holder from the dispensing group when
coffee is being dispensed.
Do not insert your fingers or any other objects into the filter holder.
STOP
PROG.
;
STOP
PROG.
STOP
PROG.
STOP
PROG.
39