Argo POLIFEMO SLIM Instructions D'utilisation page 20

THE TANK MUST BE FILLED WITH DEMINERALIZED WATER FOR THE APPLIANCE TO
OPERATE IN COOLER/HUMIDIFIER MODE.
Before turning on the appliance, remove the two lateral tank locks by turning them, and extract the tank located in the
back of the appliance. Before completely removing the tank, it is necessary to disconnect the water pump. Remove the
water pump block by turning it, as shown in the figures below, once the tank has been emptied and cleaned, reposition
the water pump by turning the block again. Make sure it is securely attached to the tank.
Add demineralized water directly to the water tank. Fill the tank up to the maximum limit indicated, it will be possible to
view the water level through a transparent window, located on the front panel of the unit. Once the tank has been filled,
put it back in its place and reposition the tank locks.
V 01/21
FILLING THE WATER TANK
Tank lock
Maximum water level in the tank
Minimum water level in the tank
20