Battery Charging - Scrambler Ducati CITY CROSS-E X Mode D'emploi

Instructions:
- Open the kickstand
- Switch off the item
CAUTION
Prior to using the item for the first time, charge to 100%. Ensure the item, charger, and charging port are dry.
Model Reference picture
City
Cross-E X
To recharge the item, use the battery charger supplied ONLY
CAUTION
Model
CITY CROSS-E X
Using another type of charger may damage the scooter or entail other potential risks.
Never leave the item unsupervised while it is charging. Do not switch the product on while it is charging.
After each use, fully recharge the battery to extend its useful life. Do not recharge the item immediately after use. Allow the
scooter to cool for an hour before recharging.
The item should not be charging for extended periods. Overcharging reduces battery life and poses additional potential
hazards.
Allow the vehicle to discharge completely to prevent damage to the battery.
Damage caused by the battery being left uncharged for a long period is irreversible and is not covered by the limited
warranty. Once the damage has occurred, the battery cannot be recharged (the battery must not be dismantled by
unqualified personnel, as this could lead to electric shocks, short circuits or even major safety incidents). If the owner is
away, e.g. on holiday, and the device is entrusted to a third party, leave it in a partial charge state (20-50% charge), not fully
charged.
Carry out regular visual inspection of the charger and charger cables. If the battery charger cable is clearly damaged, do not
use it to avoid further damage and/or risks; please contact us for a replacement.
4.

Battery charging

Battery charger model
FY-4202000
09
Instructions
- Remove the rubber cover from the charging socket.
- Connect the charger first to the wall outlet and then
to the charging port of the electrical scooter.
- When the item is fully charged, the light on the
charger changes from red (charging) to green
(charging complete).
- Disconnect the charger from the charging port and
then from the wall outlet.
- Re-insert the rubber cover in the charging socket of
the electrical scooter.
Output voltage
42 – 2A
Charging time
4 – 5 hours