Quick Guide - Scrambler Ducati CITY CROSS-E X Mode D'emploi

• Prior to using the item for the first time, charge to 100%.
• Check tyre pressure (see side of tyre for recommended value). If the item does not reach at least 60% of the declared
kms, or the maximum speed within the first 3 months of use, it is likely that the wheels have deflated once more. In this
case, restore pressure as indicated.
• Check and adjust the brakes.
• Turn on the display.
• Place the item on a flat surface.
• Hold the handlebar firmly using both hands. Step onto the footrest with one foot and use the other to give yourself a
gentle push and accelerate.
CAUTION
Zero Start function: The accelerator is activated once the speed of travel exceeds 3 km/h.
For safety reasons, the item is initially set up to avoid standing starts.
• When riding the item, tilt body in the riding direction during a turn and slowly turn the handlebars.
• To stop the item, release the throttle and pull the brake lever.
• To get off, first stop the vehicle. Getting off the moving electrical scooter may cause damage.
• Prior to each use, check brakes and any wear, check tyre pressure (see side of tyre for recommended value), wheel wear,
throttle and charge status of battery.
Adjustments:
Adjusting the position of the brake levers
Model Figure
City
Cross-E X
(all
versions)
Adjusting the brake calliper
Model Figure
City
Cross-E X
(all
models)
6.

Quick guide

Instructions
Refer to point A (see figure) to adjust the position of the
brake lever, if needed
Instructions
Rear brake calliper:
If the brake is too tight or too loose, use the hex wrench
to loosen screw (A), then adjust the brake wire (shorten
the brake wire from the top end if it is too tight. If the
brake cable is too loose, pull the cable downwards)and
then re-tighten the screw (A).
If it will be too loose or too tight, even after performing
the first step, it may be necessary to adjust the brake
pad (fixed) by passing through the circle (opposite side
of the brake calliper) using the Allen wrench, counter-
clockwise to distance and clockwise to draw near the pad
to the disc (D).
11