Using The Product; Connecting A Sensor; Programming Data Logger; Menu Overview - TESTO 175 Mode D'emploi

6 Using the product

The displays appear in the specified sequence.
6 Using the product
6.1.

Connecting a sensor

Observe the following points when connecting sensors to
data logger and measuring points.
> Ensure correct polarity of the plugs.
> Press the plugs firmly into the ports to ensure leak
tightness. However, do not apply force!
> Make sure that the plugs are firmly connected to the
data logger or that the connections are closed with
blanking plugs.
> Ensure correct positioning of the sensor to avoid
disturbing influences affecting the measurement.
> testo 175 T3: Always make sure that you connect the
sensor configured (via the software testo Comfort
Software) to the individual sockets. The numbers of the
connections are printed on the housing.
6.2.

Programming data logger

In order to adapt the programming of your data logger to
your individual requirements, you require the testo Comfort
Software Basic 5 software. It is available in the Internet as
a free download requiring registration
www.testo.com/download-center.
The instructions for the installation and operation
of the software can be found in the testo Comfort
Software Basic 5 instruction manual that is
downloaded together with the software.
6.3.

Menu overview

The menu overview shows exemplary display
representations of the data logger testo 175-T2.
The display must be switched on to be able to
show the corresponding indications. This is
accomplished with the software testo Comfort
Software.
The indication in the display is updated according
to the programmed measurement rate. Only
readings from active channels are displayed.
46