TESTO 175 Mode D'emploi page 52

6 Using the product
Via USB cable
1. Connect the USB cable to a free USB port on the PC.
2. Loosen the screw on the right side of the data logger.
Use a coin for this purpose.
3. Open the cover.
4. Plug the USB cable into the Mini USB port (1).
5. Read out the data logger and process the read out
data, see separate operating instructions testo Comfort
Software.
Via SD card
1. Loosen the screw on the right side of the data logger.
Use a coin for this purpose.
2. Open the cover.
3. Push the SD card into the SD card slot (2).
-
The display shows
175 T2, testo 175 T3, testo 175 H1).
[Go]
4. Hold
- The display shows
175 T2, testo 175 T3, testo 175 H1).
- The yellow LED lights during the copying process.
- The green LED flashes twice and after the copying
process the display shows OUT.
5. Remove the SD card.
6. Insert the SD card into the SD card slot on the PC.
7. Process the read out data, see separate operating
instructions testo Comfort Software.
52
Sd (testo 175 T1) or
depressed for longer than 2 seconds.
CPY
(testo 175 T1) or
Sd CArd (testo
COPY
(testo