Bosch GML 50 Professional Notice Originale page 24

OBJ_BUCH-1267-001.book Page 24 Monday, July 26, 2010 12:03 PM
24 | English
Assembly
Power Supply of the Radio Charger
The power supply of the radio charger can take
place via the mains supply or via a lithium ion
battery inserted in the charging compartment
22. When the battery is used for power supply,
only the functions audio operation and power
supply of external devices via the integrated
USB connection, are available.
Observe the mains voltage! For power supply
via mains, the voltage of the power source
must correspond with the data on the type
plate of the radio charger. Radio chargers
marked with 230 V can also be operated with
220 V.
Battery Insertion/Removal (see figure A)
Use only original Bosch Professional 14.4 V
and 18 V lithium ion batteries. Using other
batteries can lead to injuries and pose a fire
hazard.
Note: Use of batteries not suitable for the radio
charger can lead to malfunctions of or cause
damage to the radio charger.
Open locking latch 23 of the battery lid ("Charg-
er/Battery Bay") and fold out battery lid 24.
Insert a battery into the charging compartment
22 in such a manner that the connections of the
battery face against the connections in the
charging compartment 22, and allow the battery
to engage in the charging compartment.
As soon as a battery with suffi-
cient voltage is inserted, the
battery inserted indicator l ap-
pears on the display.
The battery inserted indicator l
flashes when the battery is low.
To remove the battery 25, press the release but-
ton on the battery and pull it out of the charging
compartment 22.
After inserting or removing the battery, close
the battery lid 24. Lock the battery lid by engag-
ing the locking latch 23 in the housing and then
pressing down.
If required, wear protective gloves when re-
moving the battery. The battery can heat up
considerably when charging.
1 609 929 W38 | (26.7.10)
Inserting/Replacing the Back-up
Battery (see figure A)
In order to store the time in the radio charger,
back-up batteries have to be inserted. Using
alkali-manganese batteries is recommended for
this purpose.
Open locking latch 23 of the battery lid ("Charg-
er/Battery Bay") and fold out battery lid 24.
Remove the battery 25, if required.
To open the back-up battery lid 18, press on the
latch 17 and remove the back-up battery lid. In-
sert the back-up batteries. When inserting, pay
attention to the correct polarity according to the
representation on the inside of the back-up bat-
tery compartment.
Mount the back-up battery lid 18 again.
"REPLACE AA BATTERY WHEN UNIT NO
LONGER KEEPS CORRECT TIME": Replace the
back-up batteries when the radio charger no
longer stores the time.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Remove the back-up batteries from the
radio charger when not using it for longer
periods. When storing for longer periods, the
back-up batteries can corrode and discharge
themselves.
Operation
Protect the radio charger against moisture
and direct sunlight.
Audio Operation (see figures B and C)
Some audio operation functions can also be
controlled via the remote control (see "Remote
control", page 27).
Bosch Power Tools