Becker CentronicPLUS Notice De Montage Et D'utilisation page 25

or
3s
Briefly press the programming button on the transmitter to change to the
setting mode.
▻ The receiver with the best connection quality to the transmitter
confirms.
▻ The LED ring lights up white in the lower area and shows the
current assignment status of the selected sensor in the upper
area.
If a sensor/receiver has not yet been added to the
installation (LED ring lights up yellow), it will not be
possible to select it in this way. The sensor/receiver
must be added to the installation beforehand.
Assignment status in the upper area of the LED ring
Lights up blue:
Lights up green: The receiver is assigned to the se-
Lights up red:
If you do not receive confirmation from the required re-
ceiver, you can press the / button to toggle between
the available receivers until the required receiver con-
firms.
Press the STOP button on the transmitter to change the assignment
status of the selected receiver. If the receiver is still not assigned to the
selected sensor, it will now be added.
▻ The receiver signals once to confirm the sensor assignment,
or signals twice to cancel the sensor assignment.
▻ The transmitter lights up accordingly to confirm the new as-
signment status.
Then press the programming button on the transmitter for 3 seconds to
change to normal mode.
► The LED ring goes out.
The receiver is not assigned to the
selected sensor.
lected sensor.
No receiver located.
25 - en