Start Up; Preliminary Checks - Teddington CS620 Serie Mode D'emploi

EN
5

Start up

5.1
64
Note: On the left is indicated the extension of the operating limits if operating with versions
equipped with a hot gas defrost system.

Preliminary checks

Warning: Check that all power cables are properly connected and that all terminals are secure.
Warning: The voltage must be that indicated on the label of the unit ± 5% tolerance. If this does
not happen, please contact our factory office.
Warning: before starting up, check that all the cover panels are in the correct position and are
locked with fixing screws. Attention: before starting up, check that all the cover panels are in the
correct position and are locked with fixing screws.
Warning: For temporary shutdown (night, weekend, etc.) never interrupt the power supply and
follow the procedures illustrated in the paragraph on machine shutdown.
Warning: Before to start the machine for the first time it must remains in STAND BY mode for at
least 5 hours.
In order to start the machine the general disconnector must be close: at this point the led power will
turn on.
All units are provides with a pcb that manages the unit.
In order to start the unit use the humidostat or the buttons on the controller (depending on the
machine): at this point the led working will turn on.
Operation table
M.CS620-00 ITA-ENG-FR 24/05/2021
CS