Generalities - Teddington CS620 Serie Mode D'emploi

CS
3.5

Generalities

Power supply Control circuit
Model
V/ph/Hz V/~/Hz
CS 400/1~/50 24/1~/50
Warning: Before any operation on the electrical section, make sure that the power supply is
disconnected.
EN
Warning: The main power supply must be protected with a differential switch.
Warning: A main switch must be present near the unit. Complete compliance with the rules
concerning electrical installations and installations must be guaranteed.
Check that the supply voltage corresponds to the nominal data of the unit (voltage, frequency)
shown on the plate on the machine.
The power connection is via a plug with a more neutral three-pole cable and earth.
Warning: Voltage fluctuations must not exceed ± 5% of the nominal value. If these tolerances are
not observed, please contact our Studio to provide adequate devices.
Warning: The power supply must comply with the quoted limits: otherwise the warranty will be void
immediately.
Warning: Grounding is mandatory.
61
M.CS620-00 ITA-ENG-FR 24/05/2021