Description Of The Control Unit; Description Of The Connections; Models And Technical Characteristics - Key Automation 14A Instructions Et Avertissements Pour L'installation Et L'usage

2 - INTRODUCING THE PRODUCT

2.1 - Description of the control unit

The 14A control unit is a modular system for the control of Key
Automation motors for the electric opening and closure of swing and
sliding gates, barriers and garage doors.
The 14A has a programmer with display (optional) allowing easy
4
M2
3
5
6
SBS
8
7

2.2 - Description of the connections

1. Control unit power supply connection 24 Vac
2. M1 power module socket
3. M2 power module socket
4. Display programmer connector / KUBE PRO
5. Receiver compartment RX4Y
6. Integrated STEP BY STEP control button

2.3 - Models and technical characteristics

CODE DESCRIPTION
14A Control unit with 1 PO24 power module for the control of 1 24V motor for swing and sliding gates
14AF Control unit with 1 PO24 power module for the control of 1 24V FASTLINE motor for swing and sliding gates
14AB Control unit in box with 2 PO24 power modules for the control of 2 24V motors and 150VA trasformer for swing gates
14AB2 Control unit in box with 2 PO24 power modules for the control of 2 24V motors and 250VA trasformer for swing gates
Control unit in box with 2 PO24 power modules for the control of 2 24V FASTLINE motors and 250VA trasformer for
14AB2F
swing gates
• Power supply with protection against short-circuits inside the
control unit, on motors and on the connected accessories.
• Obstacle detection by means of current sensor.
• Anti-crush safety device.
M1
2
9
programming and constant monitoring of the control unit's status; the
menu structure also allows easy setting of working times and
operating modes. The display menu is multilingual.
All other, improper, use of the control unit is forbidden.
11
1
10
WARNING:
the PO24 power
module must always
be connected/discon-
nected with the control
unit not powered up!
7. External antenna connections
8. Input status indicator LEDs
9. Accessory/input connection terminal board
10. Protective fuse, 2.5AT
11. Battery connection
• Automatic learning of working times.
• Programmable deceleration during opening and closure.
• Safety input deactivation by means of software.
• Control panel with microprocessor logic.
EN
21