KERN and SOHN MSF 200N Manuel page 9

6 Unpacking/installing
Testing upon
acceptance
Packaging/
Return
Checking the
graduation
2 x bracket
4 x dowel, "wall bracket"
4 x screw, "scales stand
bracket"
MSF-BA-EU-1818
Please check packaging as well as the device on receipt for possibly visible
external damages.
Keep all parts of the original packaging for a possibly required return.
Only use original packaging for returning.
After the assembly of the height measuring rod, the graduation must be
checked using an external measuring rod.
For this put an external, verified measuring rod with the respective accu-
rateness on the weighing plate or, in case of wall assembly, vertically on
the floor. The height measuring rod must be shifted in a way that the hori-
zontally unfolded flap touches the external measuring rod with the lower
side at 150 cm.
Information:
The measure of the external measuring rod is not congruent with the grad-
uation of the height measuring rod, it is displaced by some cm, as the offset
between the flap and the reading mark thus will be considered.
If the measure does not match exactly, loosen again slightly and shift a little
the screws used for assembly and then check again the measure of 150
cm.
Scope of supply
2 x screw „Measuring rod on tripod of
scales"
4 x screws „Measuring rod on wall with
bracket"
Operating instructions
9