Publicité
Les langues disponibles
Les langues disponibles
Operation
Loading
Approach the drum centrally with the drum lifting clamps.
-
Lower the lifting clamps right over the rim of the drum and lock there (see illustration).
-
Raise slightly to check the seating of the lifting clamps.
-
Lift drum.
-
Moving the drums
Only move raised drums at walking speed!
-
Take the greatest care when moving over uneven ground!
-
There is the danger that the load can start to swing even with careful handling!
-
Do not walk under suspended loads!
-
Unloading
Lower the drum slowly until it is standing firmly on the ground (the chain must hang loosely).
-
Release the lifting clamps from the rim of the drum.
-
Putting in an upright position
Approach the drum to be righted with the drum lifting clamps on the side that is to be the top.
-
Lower the lifting clamps right over the centre of the drum and lock on the drum rim.
-
Raise slightly to check the seating of the lifting clamps.
-
Bring the drum to an upright position
-
Release the lifting clamps from the rim of the drum.
-
Maintenance and servicing
To guarantee safe working with the product the following checks are necessary:
-
Regular check for ease of movement of the lifting grippers and if necessary lubrication with
commercially-available grease.
Take care that no grease gets on the gripping areas of the lifting grippers!
-
Regular check of the gripping areas of the lifting grippers.
If the profile is worn the drum lifting grippers must not be used:
Regular check of the chains and the crane eye for correct state
-
Annual sight and function checks by a qualified person.
-
If the following damage is established on the chains the drum lifting grippers must not be used:
a) elongation by more than 5% on the chain or a single link
b) reduction of link thickness (rated thickness) at any place by more than 10%
c) breakage of a chain link
d) fissures on a chain link
e) deformation of a chain link
If cracks, wear of more than 5% or gross deformities of the crane eye are found the drum lifting
grippers must not be used.
As proof that the tests have been carried out a test list is to be compiled and kept by the operator.
-
Fasshebeklammer
164398
Seite 6 von 19 Seiten
Ausgabe 01/2018
Publicité
