Ga.Ma Gcx623 Sport Manuel D'utilisation page 11

CUTTING LENGTH ADJUSTMENT:
The GCX623 multifunction appliance offers the possibility of making finishing
touches of 0.8 mm, 0.7 mm and 0.6 mm if used without any comb attached.
These cutting lengths are achieved using the switch found on the top of the
product (Fig. 3). But it also possible to achieve a classic hair cut to the
following lengths: 3-6-9-12 mm and to trim the beard to 2 mm using the
supplied attachment comb.
Fig.3
CLEANING AND MAINTENANCE:
A clean and properly lubricated appliance considerably improves its capacity and cutting precision.
DO NOT CLEAN ANY PART OF THE APPLIANCE UNDER RUNNING WATER.
HOW TO CLEAN THE HEADS:
Before any cleaning operation, make sure that the appliance is properly turned off and disconnected from the
power outlet.
Remove the head following the instructions provided beforehand and, using the special brush supplied,
remove any hair residues inside the appliance body, between the blades and the back of the head. Replace
the head in the initial position as explained beforehand.
The razor head can be cleaned internally. There is a black button on each side of the head; when they are
pressed, it is possible to remove the upper part of the head and remove any hair residues with the greatest
care, again using the special brush supplied. To reinsert the upper part of the head, slide the two lateral axes
inside their snap seat until you hear a slight click.
21
NEVER DISASSEMBLE THE HEAD INTO ITS INTEGRAL PARTS OR YOU WILL INVALIDATE THE
WARRANTY ON THE ENTIRE PRODUCT.
HOW AND WHEN TO LUBRICATE THE BLADE:
Before the first use we recommend lubricating the blade of the
desired head (not the head of the razor) with a drop of the oil found in
the package or with any other lubricating oil (make sure that it is not
too viscous).
Turn the multifunction appliance upside down so that oil does not
drip on the appliance. Lubricate the blade with a few drops of oil
Fig.4.
Turn the appliance on for a few seconds so that the oil is distributed evenly along the entire blade. Then, using
a dry cloth, eliminate any excess oil residues.
This procedure must be done on each of the heads fitted with blades.
We recommend repeating this procedure every two months or more often, depending on product use.
BLADE DURATION:
The duration of the blade varies based on usage frequency and times. Although correct maintenance is
performed, if the cutting efficiency is compromised, contact the manufacturer to have the entire head
replaced.
You can find the product manuals and warnings on the site www.gamaprofessional.com.
The date of production of this model mentioned on the box label in the format:
XXX - number of goods part; XX - day; XX - month; XX - year
22