Plug Safety - Fridja f1800 Manuel D'instructions

Is it possible to juice ingredients with tough fiber?
• Ingredients like celery or ginger contain long fibers that may wrap
around the juicing screw and affect the juicer's performance. When
juicing fibrous ingredients, do not collect more than 3000 mm. of juice.
After collecting this quantity or less, clean the top-set completely before
juicing again.
Discolouration of the plastic parts:
• After juicing, if the juicer is not cleaned right away, the remaining pulp
inside the top-set can dry up which can make disassembling and
cleaning hard. This can also affect the juicer's performance and colour.
• Ingredients that are rich in carotenoids such as carrots and spinach
may dye plastic parts. When the parts are dyed with carotenoids, rub
vegetable oil into the dyed areas and use mild detergent to clean.
• Vegetable oil should only be used during clean-up for parts that are
discoloured.
Do not use vegetable oil on the juicing screw or the strainer. If vegetable
oil or oil from animal fat gets on the juicing screw or the strainer, this can
affect the juicer's performance and may result in damaged parts.
• The silicone pieces on the top-set can be detached to be thoroughly
cleaned.
Using for purposes other than juicing:
• This juicer is designed to juice ingredients like fruits and vegetables.
• Do not use the juicer for extracting vegetable oil.
• Do not juice ingredients with high contents of vegetable/animal oil.
• If vegetable/animal oil gets on the juicing screw or the strainer, this can
affect the performance of the juicer and could result in damaged parts.
30
ENGLISH f1800 FRIDJA WHOLE FRUIT SLOW JUICER
P LUG SA F ET Y
The appliance is fitted with a 13 amp plug. In the event of having to change the
fuse in the plug supplied, a 13 amp ASTA approved (BS 1363) fuse must be used.
Should the plug need to be replaced for any reason, proceed as described
below. The wires in the mains lead are coloured in accordance with the
following code:
• The wire coloured green and yellow must be connected to the terminal
marked with the letter "E" or by the Earth symbol or coloured green and
yellow. Under no circumstances should either the Neutral or Live be
connected to the Earth terminal
• The wire coloured blue or black must be connected to the terminal "N".
Under no circumstances should either the Earth or Live be connected to
the Neutral terminal.
• The wire coloured brown or red must be connected to the terminal
marked "L". Under no circumstances should either the Earth or Neutral
be connected to the Live terminal.
• Upon completion there must be no cut or stray strands of wire present
and the cord clamp must be secure over the outer sheath.
If in doubt please contact a qualified electrician for advice.
Green & Yellow
Blue
Brown
Cord Clamp
31