Fridja f1800 Manuel D'instructions page 15

The drum lid will not close:
• Make sure the juicing screw is pushed all the way in to the strainer in
order for the drum lid to close properly.
• If the juicing screw is not properly in position, the drum lid may not
close.
Odd noise from the juicer:
• Check if the parts are assembled correctly. Try reassembling the parts
and listen for the odd noise.
• Do not start the juicer unless there are ingredients and/or liquid in it.
• Operating the juicer without ingredients can cause damage to the unit.
• If the juicer is operated without ingredients or liquid, the noise level can
increase and also can lead to damage.
• Noise from the juicing auger and the strainer will is occur when
ingredients are inserted into the juicer.
• If excessive noise occurs when ingredients are inserted into the juicer,
check the size of the ingredients. Do not insert anything over 1 inch in
thickness.
• Depending on the type of ingredients, the dimensions should be
smaller.
• Noise can occur if the juicer is operated on an uneven or slanted
surface. Place the juicer on a horizontally flat surface when operating.
The extracted pulp is very moist:
• During the very beginning of extraction, the pulp can be more moist.
• Depending on the ingredient's condition, the extracted pulp can be
affected; especially when the ingredient is not fresh, the juice can be
extracted with the pulp.
During operation, the juicing bowl shakes.
• The juicing screw and the strainer are set up to crush and squeeze the
ingredients. It is normal for the juicing screw and the strainer to vibrate.
• If the ingredient contains strong fiber, the vibration from the top-set may
be stronger.
28
ENGLISH f1800 FRIDJA WHOLE FRUIT SLOW JUICER
During juicing, the juicer stopped:
• Check the power cord and make sure it is plugged in correctly.
• Check that all the parts are correctly assembled.
• If too many ingredients are inserted at one time, this can cause the juicer
to stop.
• When the juicer stops because there are too many ingredients inserted
in it, press the REVERSE-OFF-FORWARD button in this order, switching
back and forth 2 to 3 times.
• The reverse setting will push the ingredients up, and the forward setting
will pull the ingredients down.
• If the juicer stops due to the overload protection, let the juicer cool for
30 minutes to 2 hours before juicing again.
• If there are hard seeds within the ingredients, remove them before
juicing. Hard seeds will damage the juicer.
Layers of separation in the juice:
• Depending on the density of the ingredients, the extracted juice may
show layers of different juices. It is different from separation due to
oxidation caused by juicing with a high-speed juicer.
The drum lid is stuck:
• After juicing, let the juicer operate for another 30 seconds to extract the
remaining pulp.
• If there is too much pulp in the top-set, this can cause the drum lid to not
open. In this situation, press the REVERSE-OFF-FORWARD button in this
order, switching back and forth 2 to 3 times.
• Pour water down the feeding tube to rinse out the insides and then try
opening the drum lid.
Juice dripping down the body of the base:
• If the silicone lip on the bottom of the juicing bowl is not plugged
in correctly, the juice may seep out on to the juicer base. Before
assembling the parts, check and make sure the compression silicone is
plugged in correctly (page 10).
29