How To Clean The Silicone Wipers; Troubleshooting Q&A - Fridja f1800 Manuel D'instructions

CAUTION:
When using frozen ingredients, make sure to thaw your frozen
ingredients for about 5 to 20 minutes before use.
(The required period to thaw the ingredients will depend
on how long the ingredients were in the freezer and the
temperature it was kept in.)
When making smoothies, add milk or other types of liquid
between ingredients.
Check the consistency of the smoothie by looking through the
juicing bowl, and add more liquid as needed.
• Please do not insert ingredients like ice, meat, oil, or fat based
ingredients. These ingredients may damage the components.
• Please remove hard or thick seeds, pits, or peel before use.

HOW TO CLEAN THE SILICONE WIPERS

The silicone wipers are removable for cleaning. After cleaning, place the
silicone wipers back onto the frame as shown in the picture.
26
ENGLISH
|
TIP
Inser t into
the slot
with the tail
pointing
down.
f1800 FRIDJA WHOLE FRUIT SLOW JUICER
T ROUBL ESH OOT ING Q&A
When there is no power to the juicer:
• Check if the power cord is properly plugged in.
• Check if the drum lid and the juicing bowl are properly assembled.
• Check if the top-set and the base are properly assembled.
• Juicer will not operate if parts are not assembled properly.
Low juice yield:
• Different ingredients hold different amounts of fluid that will yield
different amounts of juice.
• If the ingredients are not fresh, they may contain reduced amounts of
fluid, which will yield less juice.
• Check if the silicone lip is firmly inserted (page 10).
• If the ingredients have low water content, it may help to soak them in
water before juicing.
• If juicing ingredients with small seeds, after a few servings, it may reduce
the juice yield. For best result, disassemble and wash the top-set in
between juicing.
• If there is seed residue on the bottom of the strainer, this can affect
juicer performance and the overall juice yield.
There is too much pulp in the juice:
• When continuously juicing, depending on the ingredients, the juice may
contain a lot of fine pulp.
• To reduce the fine pulp, clean the top-set frequently and the pulp.
• Use a mesh strainer and put the juice through it to collect the unwanted
pulp.
• If the strainer and the auger are damaged and affecting the juicer's
performance, it is recommended the parts be replaced.
• The lifetime of each part may vary depending on length and method of
use and ingredients extracted.
• If too many ingredients are inserted at the same time, it may cause the
juicer to stop frequently. This can lead to excessive pulp in the juice.
Insert the ingredients slowly and few at a time.
27