How To Use The Ice Cream Strainer - Fridja f1800 Manuel D'instructions

4. Remove the juicing screw/auger, strainer, and rotation wiper unit from
the juicing bowl. Clean with provided brush.
Note |
• Immediately clean the juicer after each use. If remaining
residue in the juicer dries up, it can make disassembling
and clean-up difficult. The excess build up can cause poor
performance in future uses.
• For easier disassembly, place the top-set in the sink and run
the water through from the top of the top-set.
• Thoroughly dry the bottom of the juicing screw where it
connects to the metal cylinder shaft on the base.
5. Place the juicing bowl under running water and unplug the compression
silicone to clean the pulp spout.
TIP |
• Soak the juicing bowl in a solution of warm water with
baking soda or a little bit of bleach to clean the excess
build-up.
22
ENGLISH f1800 FRIDJA WHOLE FRUIT SLOW JUICER
H OW TO US E T HE ICE CRE AM ST RA INE R
1. To assemble the top set, place the juicing screw
and the blank strainer in the juicing bowl
and close the lid.
1. Insert the blank strainer into the juicing
bowl while aligning the red dots
the blank strainer and the juicing bowl.
2. Insert the juicing screw/auger into the
blank strainer with a twisting motion.
3. Place the lid onto the juicing bowl by
aligning the red dots of the lid and
the juicing bowl. Then, rotate the lid
clockwise until the lid is secured.
* When using the blank strainer,
always leave the anti drip tap open.
2. Place the assembled top-set onto the base.
Top Set
Base
Lid
of Juicing Screw
/ Auger
*use the same
juicing screw from
the Slow Juicer
Blanker Filter
Juicing Bowl
Before use, make sure the
silicone cover is correctly in
place
(CLOSE)
(OPEN)
Align the arrow from the lid with
the OPEN sign from the base and
rotate the topset clockwise until
the arrow from the lid is in
CLOSE position.
23