Load Or Remove A Wireless Sensor - Berger & Schroter MG982K-10M Mode D'emploi

4.4 Load or Remove a Wireless Sensor

Any 433 MHz wireless sensor, such as infrared body sensor, wireless
door magnet, wireless smoke detector, etc, can be set as an alarm sen-
sor of the camera.
Method to load or remove a wireless sensor:
1. Power on the wireless sensor.
2. Enter the Setup status, press Menu and enter into the Study
Code submenu. Choose a zone, for example Zone1, press OK button,
then trigger the wireless sensor to check if the sensor is loaded suc-
cessfully. When it's successful, there will be a "√" after the zone num-
ber.
For example to load a infrared body
sensor :
1. Choose a zone to start study
code.
2. Power on or trigger the wireless
sensor to study code
48