Cautions - Berger & Schroter MG982K-10M Mode D'emploi

¢ The working voltage of the camera is 6V. The camera is supplied
by the power adapter or 8 AA batteries.
¢ Please install batteries according to shown polarity.
¢ Please insert the SD card before power on camera. The camera
has no internal memory for saving images or videos. The camera
will not work if there is no SD card.
¢ Please make sure that your SIM card supports the GPRS data
business.
¢ When going into the SETUP mode, allow approximately 10-20
seconds for the camera to acquire a signal.
¢ Please unlock the write-protect switch before inserting the SD card.
¢ Please do not insert or take out the SD card when the power switch
is at ON position.
¢ It is recommended to format the SD card by the camera when used
for the first time. Many other SD cards formatted by other cameras
have poor compatibility with different brands of cameras. So it is
best to format the SD card with this camera or on a computer.
¢ In the SETUP mode, the camera will shut down automatically
after 3 minutes if no operation is done. Please turn on the power
again if you want to continue to work with the control.

2 Cautions

37