Anslut 019722 Mode D'emploi page 11

EN
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Output
Colour temperature
Luminous flux
Protection rating
Battery technique
Battery type
Battery capacity
Voltage
Size
DESCRIPTION
Handy solar cell lamps that fasten round a
handrail or railing. The lamps have twilight
sensors and automatically switch on when
darkness falls. Run on rechargeable AAA
batteries (included).
1. Solar panel
2. Casing
3. Light source
FIG. 1
SOLAR CELL POWERED LIGHT
• The product runs on solar energy via the
built-in solar panel.
• The solar panel converts solar energy to
electrical energy, which is used to charge
the rechargeable AA battery (NiMH).
10
0.015 W
3000 K
0.8 lm
IP44
NiMH
AAA
100 mAh
1.2 V
L8 x W4.5 x H4.3 cm
• The light switches on automatically when
it goes dark, and switches off in daylight.
• How long the light stays on depends on
how long the solar panel has been
exposed to sunlight.
– Long exposure to sunlight produces
longer lighting up.
– For best functionality, place the
product so that it is exposed to
sunlight and is therefore charged for
as long as possible.
– With maximum exposure to sunlight
the light will shine for up to 8 hours.
ASSEMBLY
Read all the instructions carefully before
assembly.
1. Carefully remove all the parts from the
packaging.
2. Start the product by pulling off the plastic
tab between the battery and the contact
plate.
FIG. 2
3. Place the product in the required place.
FIG. 3
MAINTENANCE
REPLACING THE BATTERY
1. Follow the instructions to replace the
rechargeable AAA battery (NiMH).
2. Unscrew the screws on the bottom of the
casing with a screwdriver and open the
battery cover.
FIG. 4
FIG. 5
3. Replace the battery with a new one of
the same type (rechargeable AAA battery,
1.2 VDC, 100 mAh, NiMH).
FIG. 6