Non hazardous surface sensing thermostat
The T-M-10-S/+x+y is used for temperature control of electric heaters in
industrial plants. It is suitable for frost protection and temperature
maintenance at different temperature ranges. Because of its high breaking
capacity of 3700 VA it is also suitable for switching the heater directly up to
this power. The direct connection of the heating-tape or heating-cable is
possible.
The bulb and capillary tube thermostat can be used alternatively as air- or
clip-on thermostat.
The thermostat is mounted in a weatherproof polyester enclosure, which is
IP 65 rated.
1. Safety instructions
The device meets the VDE 0631 and VDE 0100 regulations. It is necessary
to observe the following rules:
Attention!
The device is an electric equipment.
Installation, maintenance and repair should only be carried out by quali-
fied personnel.
Opening of the device:
Before opening the cover or removing parts with tools, the device must be
isolated from any supply-terminals!
Defects and damage:
If a safe operation is no longer possible, the device must be disconnected
and protected against accidental use.
This is the case when
• the device has visible damage from storage or transport
• the device no longer works
Earthing:
The earth protection of the heating circuit is connected to the terminal
board of the controller. Therefor the controller must be connected with
earth protection.
Voltage:
Before connecting the device to the power supply, make sure that the line
voltage and the voltage of the device are the same.
4