Télécharger Imprimer la page

RIB STOPPER MASTER Mode D'emploi page 3

Masquer les pouces Voir aussi pour STOPPER MASTER:

Publicité

Les langues disponibles

Les langues disponibles

G
IMPORTANT SAFETY INSTRUCTIONS FOR THE INSTALLATION
B
- ATTENTION -
FOR THE SAFETY OF THE PEOPLE IT IS IMPORTANT TO FOLLOW ALL THE
INSTRUCTIONS.
FOLLOW ALL INSTALLATION INSTRUCTIONS
1° - This handbook is exclusively addressed to the specialized personnel who knows
the constructive criteria and the protection devices against the accidents for
motorized gates, doors and main doors (follow the standards and the laws in
force).
2° - The wiring harness of the different electric components external to the operator
(for example photoelectric cells, flashlights etc.) must be carried out according to
the EN 60204-1.
3° - The possible assembly of a keyboard for the manual control of the movement must
be done by positioning the keyboard so that the person operating it does not find
himself in a dangerous position; moreover, the risk of accidental activation of the
buttons must be reduced.
4° - Keep the automatism controls (push-button panel, remote control etc.) out of the
children way. The controls must be placed at a minimum height of 1,5 m from the
ground and outside the range of the mobile parts.
5° - Before carrying out any installation, regulation or maintenance operation of the
system, take off the voltage by operating on the special magnetothermic switch
connected upstream it.
THE RIB COMPANY DOES NOT ACCEPT ANY RESPONSIBILITY for possible damages caused
by the non observance during the installation of the safety standards and of the laws
in force at present.
KEEP THESE INSTRUCTIONS WITH CARE
1° - If it is not forecast in the electric gearcase, install a switch of magnetothermic type
upstream, (omni polar with minimum port of the contacts of 3 mm) with a check of
conformity to the international standards. Such devise must be protected against
the accidental lockup (for example by installing inside a locked board).
2° - For the section and the type of the motor cables, RIB advices to use a cable of the
H05RN-F type with minimum section of 2,5 sqmm and, in any case, to keep to the
IEC 364 standard and to the installation standards in force in your country.
N.B.: The system must be grounded
Data described by this manual are only Indicative and RIB reserves to modify them at any
time. Install the system complying with current standards and regulations.
ITALIANO
RAEE - Informazione agli utilizzatori
Il simbolo del cassonetto barrato riportato sull'apparecchiatura o sulla sua
confezione indica che il prodotto alla fine della propria vita utile deve essere raccolto
separatamente dagli altri rifiuti. L'utente dovrà, pertanto, conferire l'apparecchiatura giunta
a fine vita agli idonei centri comunali di raccolta differenziata dei rifiuti elettrotecnici ed
elettronici. In alternativa alla gestione autonoma, è possibile consegnare gratuitamente
l'apparecchiatura che si desidera smaltire al distributore, al momento dell'acquisto di una nuova
apparecchiatura di tipo equivalente. Presso i distributori di prodotti elettronici con superficie
di vendita di almeno 400 m2 è inoltre possibile consegnare gratuitamente, senza obbligo di
acquisto, i prodotti elettronici da smaltire con dimensioni inferiori a 25 cm. L'adeguata raccolta
differenziata per l'avvio successivo dell'apparecchiatura dismessa al riciclaggio, al trattamento
e allo smaltimento ambientalmente compatibile contribuisce ad evitare possibili effetti
negativi sull'ambiente e sulla salute e favorisce il reimpiego e/o riciclo dei materiali di cui è
composta l'apparecchiatura.
L'eliminazione dei materiali va fatta rispettando le norme vigenti. Non gettate il vostro
apparecchio scartato, le pile o le batterie usate nei rifiuti domestici. Avete la responsabilità
di restituire tutti i vostri rifiuti da apparecchiature elettriche o elettroniche lasciandoli in un
punto di raccolta dedicato al loro riciclo.
FRANÇAIS
DEEE - Informations pour les utilisateurs
Le symbole du caisson barre, la ou il est reporte sur l'appareil ou l'emballage, indique que
le produit en fin de vie doit etre collecte separement des autres dechets. Au terme de la
duree de vie du produit, l'utilisateur devra se charger de le remettre a un centre de collecte
separee ou bien au revendeur lors de l'achat d'un nouveau produit. Il est possible de remettre
gratuitement, sans obligation d'achat, les produits a eliminer de dimensions inferieures a 25 cm
aux revendeurs dont la surface de vente est d'au moins 400 m2. La collecte separee appropriee
pour l'envoi successif de l'appareil en fin de vie au recyclage, au traitement et a l'elimination
dans le respect de l'environnement contribue a eviter les effets negatifs sur l'environnement
et sur la sante et favorise le reemploi et/ou le recyclage des materiaux dont l'appareil est
compose.
Eliminez les matériaux en respectant les normes en vigueur. Ne jetez ni les vieux appareils,
ni les piles, ni les batteries usées avec les ordures domestiques. Vous devez confier tous vos
déchets d'appareils électriques ou électroniques à un centre de collecte différenciée, préposé
à leur recyclage.
ENGLISH
WEEE - Information for users
If the crossed-out bin symbol appears on the equipment or packaging, this means the product
must not be included with other general waste at the end of its working life. The user must
take the worn product to a sorted waste center, or return it to the retailer when purchasing
a new one. Products for disposal can be consigned free of charge (without any new purchase
obligation) to retailers with a sales area of at least 400 m2, if they measure less than 25 cm. An
efficient sorted waste collection for the environmentally friendly disposal of the used device,
or its subsequent recycling, helps avoid the potential negative effects on the environment and
people's health, and encourages the re-use and/or recycling of the construction materials.
Materials must be disposed of in accordance with the regulations in force. Do not throw away
your discarded equipment or used batteries with household waste. You are responsible for
taking all your waste electrical and electronic equipment to a suitable recycling centre.
3

Publicité

loading

Ce manuel est également adapté pour:

Stopper slaveAa51200Aa51205