Cleaning; Troubleshooting - AKG PERCEPTION 820 TUBE Mode D'emploi

L
Important!
6.1 Replacing Fuses
L
Warning!
Fig. 20: Opening the fuse
compartment.
16

5 Cleaning

• To avoid electric shock, make sure to disconnect the Remote Control Unit from
power before cleaning the microphone or the Remote Control Unit.
1. Disconnect the power cord from the Remote control Unit.
2. To clean the surfaces of the microphone body and Remote Control Unit, use a soft cloth
moistened with water.

6 Troubleshooting

• Dangerous voltages may be present inside the Remote Control Unit. To avoid elec-
tric shock, injury, and fire, UNDER ALL CIRCUMSTANCES disconnect the power
cord from the Remote Control Unit before replacing a fuse.
• To avoid damage, replace blown fuses with new fuses of the same type and rat-
ing only.
The fuse protecting the primary circuit is located in the marked fuse compartment below the
AC input connector on the Remote Control Unit rear panel.
To replace the fuse,
1. Use a flat-blade screwdriver to open the fuse compartment lid.
2. Remove the blown fuse.
3. Insert a new fuse of the same type and rating (125 mA/250 V slow-blow).
4. Close the fuse compartment lid.
PERCEPTION 820 TUBE