Replacing The Back Rest Cover; Care Instructions; Cleaning The Cover; Cleaning The Plastic Parts - KIDDY Phoenixfix 3 Guide D'utilisation

Masquer les pouces Voir aussi pour Phoenixfix 3:

Table des Matières

Les langues disponibles

9.9 Replacing the back rest cover

Put the headrest (F) into the highest position. For easier cover replacement,

place the seat on an even surface.

Now pull the cover over the left and right shoulder rests (G) and adjust the cover

so that it lies evenly on the backrest (B) and doesn't pull.

Then close the two hook and loop fasteners on the rear side of the shoulder

rests (G).

The covers are an essential component of the safety concept. Therefore, only

the manufacturer's original covers may be used. Replacement covers can be

ordered from specialist dealers.

The cover can be washed in gentle cycle at 30 . Do

not use the spinning cycle and do not tumble dry.

The impact shield cover may not be removed or washed!

Plastic parts can be cleaned with a mild detergent or with a damp cloth. Never

use aggressive cleaning agents (e.g. solvents).

After an accident with an impact speed greater than 10 km/h, the child restraint

system must be sent back to the manufacturer without fail, to be checked for

possible damages and replaced if necessary.

Table des Matières

Table des Matières