Removal Of The K-Fix + After Semi-Universal Use; Removing And Applying The Cover; Removing The Back Rest Cover - KIDDY Phoenixfix 3 Guide D'utilisation

Masquer les pouces Voir aussi pour Phoenixfix 3:

Table des Matières

Les langues disponibles

Before driving, ensure that the lap and shoulder belts are correctly positioned

on the impact shield (L), are seated tightly, and are not twisted. The belts must

lie flat over the belt guide area of the impact shield (Fig. 23+24). Check the belt

run regularly.

8 Removal of the k-fix + after semi-universal use

Actuate the unlocking handle (K) (Fig. 25, No. 1) while simultaneously pulling the

seat (E) away from the vehicle back rest (Fig. 25, No. 2).

Open the left and right k-fix

nisms (S) forward (over the 'green' locking display (R)) (Fig. 26).

The kiddy phoenixfix 3 is uncoupled from the vehicle structure when both

connectors (D) are open.

Finally, the k-fix

connectors (D) must be retracted into the seat.

To do so, rotate the connectors (D) towards the seat (Fig. 27). For this purpose,

actuate the unlocking handle (K) (Fig. 28, No. 1) and push the connectors (D)

completely into the seat (E) (Fig. 28, No. 2). The connectors must be correctly

retracted into their respective recesses in the seat.

Now release the unlocking handle (K).

Never use your Kiddy child restraint system without the original

cover. The cover is part of the safety concept.

First put the headrest (F) into the highest position.

connectors (D) by sliding the unlocking mecha-

Table des Matières

Table des Matières