Teac A-H380 Manuel Du Propriétaire page 7

A LINE IN/OUT jacks
These jacks transmit an analog 2-channel audio signal. Connect
the components using RCA cables.
Make sure to connect the cables as follows:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
White (L)
Red (R)
< Be sure to insert each plug securely. To prevent hum and noise,
avoid bundling the signal interconnection cables together with
the AC power cord or speaker cables.
B PHONO jacks
Connect the turntable's RCA pin cord to the PHONO jacks.
Make sure to connect the cables as follows:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
< Be sure to insert each plug securely. To prevent hum and noise,
avoid bundling the signal interconnection cables together with
the AC power cord or speaker cables.
C SIGNAL GND
Connect the ground lead of the turntable to this terminal.
< This is not a safety earth.
D AC OUTLET
You can connect the AC power cord of your component.
This outlet is active only when the unit is on or standby. When
the unit is off, the outlet is inactive.
Caution:
Make sure that the total power consumption of all equipment
connected to this outlet does not exceed 100 watts (or 500mA).
E AC Inlet
Use only the supplied power cord.
< Use of other power cord may result in fire or electric shock.
< Unplug the power cord when you are not going to use the unit
for an extended period of time.
F iPod port
Connect the DS-20 iPod dock (option) to this port.
< Make sure the label A side of the plug is up.
< Securely insert the plug until a slight "click" is heard.
To disconnect the Dock:
Squeeze both sides of the plug and pull.
White (L)
Red (R)
Compatible iPod Software
In case your iPod will not work with the A-H380 or with the
remote control unit, software update may solve the problem.
Visit the Apple website and download the latest iPod Software.
iPod is a trademark of Apple Inc., registered in the U.S. and other
countries.
G VIDEO OUT terminal
This terminal outputs video signal from iPod. Use a composite
video cable to connect the Dock to the composite video
connector of a television or monitor.
H S-VIDEO OUT terminal
This terminal outputs S-video signal from iPod. Use an S-
video cable to connect the Dock to the S-video input of a
suitably equipped television or monitor. Use this connection in
preference to a composite video connection.
label side