K&S BASIC KSB 22i S Mode D'emploi page 20

IMPORTANT!
When the generator is running, the battery is charged automatically. If it is necessary to charge the
battery with an external device, we recommend using the KS B1A charger or the charger for charging
lead-acid motorcycle batteries with a nominal voltage of 12V with a charge current of not more than 2A.
If the DC protector turns off again, stop the battery charging process because the current of the operating electrical
device is higher than the rated current. Do not charge batteries if their current consumption is higher than 8.3 A (de-
pending on the generator model).
ATTENTION – DANGER!
This manual compliance! You can find a list of service center addresses on the website of exclusive importer:
www.ks-power.de/en
Level check
Motor oil
Replacement
Check /Cleaning
Air filter
Replacement
Cleaning
Spark plug
Replacement
Level check
Fuel tank
Cleaning
Fuel filter
Check (clean out)
- If the generator often operates at high temperature or high load, the oil should be replaced every 25 operating hours.
- If the engine often runs in dusty or other harsh conditions, clean the air filter every 10 operating hours.
- If you missed the maintenance time, perform it as soon as possible to save the generator engine.
IMPORTANT!
Use oils designed for four-stroke cycle vehicle engines
SAE10W-30, SAE10W-40. Motor oils with other viscosity levels,
may be used only if the average air temperature in your region
does not exceed the limits of the temperature range, specified
in the table.
Inverter generators from K&S BASIC are equipped with lithium
batteries with an operating voltage similar to conventional
lead-acid batteries.
Never smoke or interrupt battery connections to the generator while
the battery is being charged.
TECHNICAL MAINTENANCE WORKS
The manufacturer shall not be liable for any damage caused by
failure to perform maintenance work.
MAINTENANCE
RECOMMENDED OILS
10W-30, 10W-40
-20 -20 -10 -10 10 10
0
www.ks-power.de/en
9
10
C C
20 20 30 30 40 40 0 0
| 19