K&S BASIC KSB 22i S Mode D'emploi page 19

Lösen Sie bei Modelle KSB 22i S die 2 Schrauben an
der Seitenwand mit einem Schlüssel #8. Lösen Sie die
Ablassschraube C am Vergaser und lassen Sie den ver-
bleibenden Kraftstoff durch das Rohr D in die dafür
vorgesehene Tropfschale ablaufen. Benzinlecks sollten
vermieden werden. Ziehen Sie die Schraube fest. Brin-
gen Sie den Gehäusedeckel des Generators wieder an.
Lassen Sie den Generator mit Flüssiggas laufen.
ECON FUNCTION ECON FUNCTION
1. Start the engine.
2. Set the ECON switch to "ON".
3. Plug the device into an AC outlet.
4. Make sure the AC indicator light is on.
5. Turn on the electrical device.
IMPORTANT!
"ON" MODE "ON" MODE
When the ECON switch is in the "ON" position, the control unit monitors the engine speed, reducing it commensurate
with the connected load. If the engine speed is not enough to generate electricity to provide the load, the control unit will
automatically increase the engine speed.
As a result, fuel consumption is optimized and noise levels are reduced.
"OFF" MODE "OFF" MODE
The ECON switch must be set back to "OFF" when using electrical devices requiring a high starting current, such as a
compressor or submersible pump.
IMPORTANT!
DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR! DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator with the devices turned on. This may disable the generator or devices connected to it!
TO STOP THE ENGINE, PROCEED AS FOLLOWS:
1. Turn off all devices.
2. Allow the generator to run idle for approx. 1-2 minutes.
3. Set the engine switch to the "OFF" position.
4. Turn the air choke control knob to the "OFF" position (fig. 4).
5. Allow the generator to cool down.
6. Unplug the devices.
7. After the generator stops, allow it to cool down and close the air vent on
the fuel cap (set to OFF, as shown in fig. 3).
KSВ 22i S
FUNCTIONAL DESCRIPTION
OF INVERTER GENERATORS
The ECON switch must be set to "OFF" to increase engine speed
to nominal. When connecting multiple power consumers to the
generator, be sure to first connect the one with the highest starting
current, and the device with the lowest starting current should be
connected last.
The ECON switch must be set back to "OFF" when using electrical
devices requiring a high starting current, such as a compressor or
submersible pump.
С
www.ks-power.de/en
D
8
Fig. 3
Fig. 4
| 18