Installation; Before The Installation; Connection Cable - AEG ITE42600KB Notice D'utilisation

3. INSTALLATION

WARNING!
Refer to Safety chapters.

3.1 Before the installation

Before you install the appliance, write down
the information bellow from the rating plate.
The rating plate is on the bottom of the
appliance.
Serial number ...........................
3.2 Built-in appliance
Only use the built-in appliances after you
assemble the appliance into correct built-in
units and work surfaces that align to the
standards.

3.3 Connection cable

• The appliance is supplied with a
connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F which withstands a
temperature of 90 °C or higher. Contact
an Authorised Service Centre. The
connection cable may only be replaced by
a qualified electrician.
3.4 Attaching the seal - On-top
installation
1. Clean the worktop around the cut out
area.
2. Attach the supplied 2x6mm seal stripe to
the lower edge of the appliance, along
the outer edge of the glass ceramic. Do
not stretch it. Make sure that the ends of
the seal stripe are located in the middle
of one side of the appliance.
3. Add some millimetres to the length when
you cut the seal stripe.
4. Join the two ends of the seal stripe
together.
3.5 Assembly
min.
500mm
360
min.
50mm
min.
2mm
520
ENGLISH 61