Klarstein 10030917 Mode D'emploi page 16

Setting the temperature
Press" 1 „to set the temperature, " 10 „and" 9 „will flash , then press" 2 „or" 3 „arrow buttons to add 1"C or
reduce 1·c. The maximum setting temperature is 45"C, while the minimum one is 5"C. Keeping pressing" 2
„or" 3 „to add or reduce 1 ·c in 0. 5 S. The last setting temperature is the valid one. If no operation within
3S, the system will return the running state, " 9 „indicator will not flesh while room temperature is displayed.
Switching the display between degrees Fahrenheit and Celsius
Press the keys SET and UP (the two keys on the left) simultaneously for about 10 seconds.
Setting timer
Press" 1 „once again to set timer, setting time is displayed while timer indicator flesh (the timer unite is hour).
Pressing" 2 „or" 3 „to add or reduce 1 hour, the timer range is 0-2 4 hour.
Keeping pressing" 2 „or" 3 „to add or reduce 1 hour in 0.5 second. The factory-set timer is 0 hour. With indi-
cator lighting, the system starts to time according to last setting time if there is no operation for 5 seconds.
Each time" 2 „or" 3 „is pressed to set timer, system restarts to time by new time, or it does by original one till
timing is over, then turns off and stops working. The unit is turned off without buzz hint when timing is over.
Turn off
Keeping pressing" 4 „in any status to turn off the unit and power indicator keep light.
Children safety lock function
Under the working mode, press both" 2 „ or „ 3 „at the same time for 3 seconds to lock the system. Then a
square"[J"is displayed. Methods to unlock:
1) Shut off the electric machine. 2) Press both" 5" or „ 6 „for 3 seconds.
Power selected
When did not enter any models, pressing" 2 "to select the output power, the heater will work the full rated
output while" 7 "is displayed. Pressing" 3 "to switch to" 6 "heating mode. Or through high/low on the remote
control switch button" 12 "to choose the output power.
Take on the generator (ion) (optional function)
ION indicator keep light, pressing the generator (ION) button" 11 „, the ionizer function will
be on or off.
Wake-up function
The heater shows only area temperature on screen when in ready mode. You just touch (press) the screen
below the numbers, then it wakes up and you could control its functions.
The sound hint of key-press
Press any button there have buzzer ringing sound.
16