Télécharger Imprimer la page

Andis MLC Instructions D'utilisation Et D'entretien page 6

Publicité

Les langues disponibles

Les langues disponibles

The clipper has not been charged at the factory. Please charge the clipper for
2 hours before the first use for maximum performance.
You can keep the clipper plugged into the charging stand or adapter when not in
use. The charging stand or adapter will maintain the battery at full charge. We
recommend that the charging stand or adapter be unplugged if the clipper won't
be used for seven or more days.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure on/off switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper or charging
stand. Twist the adapter cord slightly to ensure good electrical connection.
4. If failure to charge still exists, return clipper to Andis or an Andis authorized
service station for examination and repair or replacement.
CORDED OPERATION
If the clipper powers OFF in the middle of a clipping job, the power cord can be
attached to continue use in corded operation. Plug the adapter cord directly into
the bottom of the clipper (Figure B). When the clipper is running with the adapter
cord attached, the clipper indicator light will remain solid blue ON to indicate
strong power, even if the battery is not fully charged. The clipper will charge at a
slower rate while in use with the cord attached.
CLIPPER INDICATOR LIGHT STATUS
When the clipper is running in
cordless operation, a blue clipper
indicator light (Figure B) means the
battery has a strong charge. When
the light turns red, the battery
level is low and should be
recharged as soon as possible. If
the clipper automatically powers
OFF, move the power switch to
the OFF position and either
charge in the charging stand or
plug in to the cord to continue
trimming.
The clipper automatically
powering off protects the lithium-
ion battery and is not a
malfunction. The clipper will
resume normal operation when it
is recharged or plugged in to the
power cord. The MLC clipper, by design, will run at full power until the battery
is fully depleted.
6
CLIPPER INDICATOR LIGHT STATUS
Clipper in Charging Stand
Fully Charged
Charging
Clipper in Use (Cordless)
Full Charge
Low Charge
Clipper in Use (Corded)
Running
OFF with Full Charge
OFF without full charge
Solid Blue
Blue Fade In and Out
Solid Blue
Solid Red
Solid Blue
Solid Blue
Blue Fade In and Out

Publicité

loading

Ce manuel est également adapté pour:

202755