Andis MLC Instructions D'utilisation Et D'entretien page 4

attempt to replace battery. When repair or
replacement is required, send or take it to an
Andis authorized service station.
14. Batteries can be harmful to the environment if
disposed of improperly. Many communities offer
recycling or battery collection. Contact your local
government about disposal practices in your
area.
15. Plug adapter cord directly into an AC outlet. Do
not use an extension cord.
16. WARNING: Never touch both terminals on
clipper with metal objects and/or body parts, as
short circuit may result. Keep away from children.
Failure to comply with these warnings could result
in fire or serious injury.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
CHARGING CLIPPER USING CHARGING STAND
The AC adapter is intended for use with Andis model MLC lithium-ion clipper
battery with a rated capacity of 4.5V
from the carton. Plug the AC adapter into a 120V AC outlet, or according to your
local power standards. Plug the adapter cord into the receptable on the back of the
charging stand (Figure A). Place clipper in the charging stand. The ON/OFF switch
on the clipper must be in the OFF position for the battery to charge. The clipper
indicator light will fade in and out blue while charging. Note that the clipper can be
removed at any time during the charging cycle without harming the clipper or
battery. Once the battery is fully charged, the clipper indicator light (Figure B) will
turn solid blue.
4
1.2A. Remove the clipper and AC adapter