Quick TFH3 Mode D'emploi Et D'installation page 6

CHARACTERISTICS - INSTALLATION
EN
The installation of the fuseholder must be carried out by qualified personnel.
BEFORE USING THE FUSEHOLDER, READ THIS INSTRUCTION MANUAL CAREFULLY. IF IN DOUBT, CONTACT
YOUR NEAREST QUICK
F
In case of discordance or errors in translation between the translated version and the original text in the Italian language,
reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
THE FUSEHOLDER IS DESIGNED FOR FIXED INTERNAL INSTALLATIONS ONLY.
The Fuseholder has been designed and constructed for the purposes described in this instruction manual. Quick® shall not be
held responsible for any direct or indirect property damage or personal injury caused by inappropriate or unintended use of the
equipment, incorrect installation or any errors that may be present in this manual.
THE PACKAGE CONTAINS: fuseholder - set of nuts, washers and grower washers to fit fuses - conditions of warranty - user's
manual.
INSTALLATION SITE
Install the fuseholder in a dry, ventilated place. The fuseholder has to be fixed to the bearing surface using screws suitable to
bear the weight of the fuseholder plus wires.
The fuseholder perimeter must be at least 5 cm (3/16" in) from any walls or objects.
The base to which the fuseholder is fixed must endure a temperature of 80 °C.
WARNING: properly tighten the nuts of the fuseholder. Otherwise, dangerous overheating of both fuse and fuseholder
may occur.
WARNING: some fuseholder components may reach high temperatures (burn hazard). Leave the fuseholder to cool off
before handling it.
WARNING: before connecting or disconnecting fuses or wires from the electrical terminals of the fuseholder, make sure
that the wires are not live.
FUSE INSTALLATION
1
2
6
RETAILER OR CUSTOMER SERVICE.
®
FUSE
TFH3
.
®
NUT
GROWER
WASHER
NUT
GROWER
WASHER
TFH3 FUSEHOLDER - REV001B