Electrolux EC4230AOW2 Notice D'utilisation page 6

6 www.electrolux.com
3.2 Switching on
7
6
1. Insert the plug into the wall socket.
2. Turn the Temperature Regulator to
the Full Loaded position and let the
appliance run for 24 hours to allow
the correct temperature to be
reached before placing food inside.
The power indicator light will light up.
3. Adjust the Temperature Regulator
according to the quantity of the
stored foods.
3.3 Switching off
Turn the Temperature regulator to the
OFF position.
3.4 Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
• to obtain the minimum coldness, turn
the Temperature Regulator toward
lower settings.
• to obtain the maximum coldness. turn
the Temperature Regulator toward
higher settings.
In case of freezing less food
volumes, the Half Loaded
setting is the most suitable.
In case of freezing much
food volumes, the Full
Loaded setting is the most
suitable.
1
2
A
B
3
4
C
5
A. Temperature Regulator
B. Half Loaded position
C. Full Loaded position
Electrolux chest freezers can
be placed at -15°C but the
user should take care about
the thermostat setting if the
appliance is assembled with
mechanical thermostat:
• When the room
temperature is lower than
-10°C, the consumer
should turn the
thermostat into the
setting number 4 to reach
good storing temperature
in the chest freezer (less
or equal -18°C).
• If the thermostat setting is
number 1 and the
ambient temperature is
-15°C, the compressor
will be not switched on by
the thermostat so the
frozen foods will warm up
to the ambient
temperature (in this case
-15°C).
3.5 High temperature alarm
An increase in the temperature in the
freezer (for example due to an power
failure) is indicated by:
• switching on of the Alarm light
• sounding of buzzer
During the alarm phase, don't place food
inside the freezer.
When normal conditions are restored the
Alarm light will switch off automatically.