Treatment Session; After Your Treatment Session - TensCare perfect mamaTENS Instructions D'utilisation

Warning: Do not use other
cords than the one provided.
Alternative pad placements
caesarean
The electrodes can be placed in a
crossed pattern with close proximity to
suture site over the incision, two being
above and two below the incision.

11.4. TREATMENT SESSION

1) Press and hold the ON button on the
control unit for 3 to 5 seconds to
switch the control unit on.
The LCD display will appear as A1
00 indicating that the unit has set
itself into Labour Pain Phase A and
Mode 1 at Zero intensity (00 mA).
2) You can now adjust the intensity of
the stimulation with the buttons ▲
and ▼ until you reach a comfortable
level. The LCD display shows the
strength of intensity.
3) Just remember
programmes A, B and C which you
can choose at any time as your
labour progresses, and when you
need a boost, just press the BOOST
button (see section 7).
Note: If the sensation becomes
uncomfortable,
intensity.
for
11.5. AFTER YOUR
TREATMENT SESSION
After use, press and hold the OFF
button on the control unit for 3 to 5
seconds to switch the control unit off
1) Once the unit off, remove the
electrode pads from your skin by
holding the pad itself and gently
pulling.
2) Replace the electrode pads to their
protective plastic shield and return
them to the re-sealable plastic bag.
Note: When removing the
electrode pads, DO NOT PULL
ON LEAD WIRES.
Before the birth, you can use your
Perfect mamaTENS to help with back
pain, and after with post birth pain.
Perfect mamaTENS programme A1
stimulation can be used with the breast
electrode pads* (see E-CMR60130) to
help initiate lactation. However, it is not
intended to treat any medical issues
and your
appropriate therapy should be to
consult your
advisor.
20
the three
reduce
first step in deciding
professional medical
the