Safety Precautions During Installation And Use - Ultraflex UP 18 Manuel D'installation Et De Maintenance

4 - SAFETY WARNINGS
This section aims to illustrate the safety rules to be followed for proper use of the equipment.
It is recommended to read this section very carefully. It is recommended to read the manuals
supplied with the other components of the steering system.

4.1 SAFETY PRECAUTIONS DURING INSTALLATION AND USE

STRICTLY FOLLOW the instructions and safety criteria set out below.
responsibility for failure by the user to comply with these standards or for any negligence
committed while using the equipment.
DANGER
• DO NOT PLACE HANDS BETWEEN MOVING PARTS.
• Do not disable or in any case disengage the safety devices.
• Do not change or add devices to the system, without prior written authorisation or
technical inspection carried out by
suitably compiled, of the change made.
• Do not use the equipment for a purpose other than that it was designed for, as specified
in the installation and maintenance manual.
• Do not appoint unqualified staff to install the system.
• Do not disassemble the hydraulic connections without first having completely drained the oil
from the system. The hoses may contain high-pressure oil.
CAUTION
• Do not stand with your feet on the cylinder and do not place material on it.
• After installing and bleeding the system, perform a check before start sailing. Turn
the steering wheel until the cylinder reaches its end stroke. Repeat the manoeuvre by
turning the steering wheel in the opposite direction. Repeat until you are sure about
the correct installation and excellent operation of the system.
• Be particularly careful in applying the thread sealant. If the latter accidentally enters
into the hydraulic system causes damage and breakage.
• To seal the fittings, do not use, under any circumstances, Teflon tape or any type of
adhesive tape, which could be sucked by the system and cause irreparable damage.
• During the installation of the system, take great care in maintaining the highest degree
of cleanliness, to prevent any foreign body from entering the system itself. Even the
smallest residue may cause permanent damage not immediately noticeable.
• Avoid too tight bending radii of hoses.
• Avoid contact of hoses with border or sharp edges and heat sources.
24
page -
PUMP FOR HYDRAULIC SYSTEMS
Installation and Maintenance Manual
giving evidence, in a description sheet
bears no