Installation and Maintenance Manual
6
Use the 4 fastening screws (7), the 4 washers (8) and the 4 self-locking nuts (9), to fasten
the pump to the dashboard.
Tighten the nuts using a 10 mm wrench with a 10 Nm (7.4 lb ft) torque.
10
7
9
8
CAUTION
If the self-locking nuts are removed (9), they must be replaced.
Please contact our service department, see the "INFORMATION LETTER" section.
WARNING
Install the pump with the filling hole (10) positioned up high (see figure) to enable complete filling
and venting of the system (see par. 3.4 "FILLING AND VENTING").
18
page
-
PUMP FOR HYDRAULIC SYSTEMS