Ultraflex UP 18 Manuel D'installation Et De Maintenance page 19

Installation and Maintenance Manual
7
Fit the steering wheel (11), supplied separately, on the shaft (12) by inserting the specific
key (13) in its compartment.
Insert the washer (14) and use a 19mm hexagonal wrench to tighten the self-locking nut (15) with
a 40 Nm (29.5 lb ft) torque: before screwing in the nut, you are advised to apply some galling-
proof grease, such as MOLYKOTE® 1000 or equivalent on the threading.
13
11
12
14
15
CAUTION
If the self-locking nut (15) is dismantled, it should be replaced. Contact our support service, see
the "INFORMATION" section.
19
page
PUMP FOR HYDRAULIC SYSTEMS -