Operating Instructions; Lighting The Grill - Pit Boss 200P Assemblage Et Fonctionnement

LIGHTING THE GRILL

1. Place the legs in up position.
2. Make sure the propane cylinder is tightly threaded into the regulator (hand
tighten only).
3. Open lid. Always open lid when lighting.
4. Push and turn Main burner knob slowly to IGNITE/HI as showed in Figure 4,
burner should light immediately
5. If ignition does not occur in 3-5 seconds, turn the control knob "OFF". Wait 5
minutes before attempting to re-light the grill. If the grill fails to ignite after the
second attempt, call Customer Care for assistance. With burner lit, gently close
the lid and allow the grill to warm up for 5 minutes prior to use.
Note: If the knob can't spark, insert the match into the lighting rod as showed in
Figure 5. Ignite the match and insert through the cooking grids to the burner.
IGNITE / HI
F
IGNITE / HI
1. Push
2. Turn knob to Ignite/HI
3. Adjust Flame
14

OPERATING INSTRUCTIONS

Figure 4
OFF OFF
IGNITE / HI
LO LO
OFF
LO
OFF
IGNITE / HI
LO
Figure 5