Use - MAXXMEE SMY-02664 Mode D'emploi

Window Cleaner Vacuum

USE

Please Note!
■
Never clean screens (televisions, com-
puter monitors etc.) with the device.
Electrical devices of this type are not
resistant to moisture.
■
Do not suck up large amounts of
water at once.
■
Only use on vertical surfaces.
■
Do not detach the water tank during
use.
■
Do not use the device when it is con-
nected to the mains power.
1. Attach the cleaning cloth to the clean-
ing attachment (4) (see the "Attach-
ing / Detaching the Cleaning Cloth"
chapter).
2. Fill the water tank (2) (see the "Filling
the Water Tank" chapter).
3. Hold the device horizontally and press
the On / Off switch (10). The control
lamp (9) is lit constantly green. The
device is in preparation mode and the
pump switches on.
4. Wait until the cleaning cloth is suf-
fi ciently damp (approx. 20 – 30 sec-
onds). Important! The cleaning cloth
should be wet, but not sodden.
5. Press the On / Off switch again. The
device switches to operating mode
and begins to clean.
6. Guide the cleaning attachment slowly
over the surface to be cleaned from
top to bottom (Picture D). The surface
is cleaned at the same time and the
dirty water is sucked up. Important!
The scraper lip should always be
placed on the surface to be cleaned
and the device should be pulled over
the surface, applying only light pres-
sure. It is not necessary to apply too
much pressure.
05487_Inlay_DE-EN-FR-NL_A5_V1.indb 17 05487_Inlay_DE-EN-FR-NL_A5_V1.indb 17
 
In operating mode, the cleaning
cloth is automatically wetted
repeatedly at regular intervals.
If it gets too dry, stop cleaning
(press the On / Off switch) and wet
the cleaning cloth again manually
(see points 3 to 5).
7. Press the On / Off switch to switch off
the device. The control lamp goes
out.
8. After use, empty the water tank and
clean the device (see the "Cleaning
and Storage" chapter).
Tips
• To guarantee the longest possible op-
erating time, we recommend charging
up the battery of the device fully
before each use.
• We recommend staying in prepara-
tion mode for approx. 30 seconds so
that the cleaning cloth is suffi ciently
moistened.
• Switch off the device after you fi nish
cleaning each surface to increase
the operating time on each battery
charge. The device can then be
placed directly into operating mode
by pressing the On / Off switch (10)
twice as it is not necessary to wet the
cleaning cloth again.
• If the cleaning cloth should become
too dry despite being regularly
moistened automatically during
operating mode, set the device to
preparation mode and maintain this
until the cleaning cloth has reached
the desired level of moistness.
EN
17
22.04.2020 11:21:04 22.04.2020 11:21:04