Filling The Water Tank; Attaching / Detaching The Cleaning Cloth; Functions - MAXXMEE SMY-02664 Mode D'emploi

EN

FILLING THE WATER TANK

1. Hold the device by the handle (11)
with one hand.
2. Reach around the water tank (2) with
your other hand and press your thumb
against the handle until the water tank
is released (Picture C). You need to
apply a little force to do this.
3. Take off the water tank.
4. Pull the fi lter plug out of the water
tank.
5. Fill the water tank with water and a
little window cleaning agent if nec-
essary. Please Note: The water tank
holds approx. 90 ml.
6. Close the water tank with the fi lter
plug. Make sure that the fi lter plug fi ts
correctly when you do this.
7. Attach the water tank to the motor
unit (8). To do this, fi rst insert the end
with the fi lter plug into the device and
press the other end against the han-
dle until you feel and hear the water
tank engage.
ATTACHING / DETACHING
THE CLEANING CLOTH
• Attaching: Place the cleaning cloth on
the hook-and-loop surface (5) on the
bottom of the cleaning attachment (4)
and press it on fi rmly.
• Detaching: Pull the cleaning cloth off
the cleaning attachment.

FUNCTIONS

• The device has an integrated fi lter sys-
tem. The dirty water which is sucked
up by the device is fi ltered so that it
can be used again for cleaning.
• The device has two different modes:
preparation mode and operating
mode.
16
05487_Inlay_DE-EN-FR-NL_A5_V1.indb 16 05487_Inlay_DE-EN-FR-NL_A5_V1.indb 16
• In preparation mode, the cleaning
cloth is wetted. In operating mode,
the suction function is switched on
to be able to suck up the dirty water.
The modes are set via the On / Off
switch (10):
○ Press 1 x: Preparation mode
○ Press 2 x: Operating mode
○ Press 3 x: Off
• The control lamp (9) shows different
charging and operating statuses.
During charging
○ fl ashing red: battery is charging
○ lit constantly green: battery is fully
charged
During use
○ lit constantly green: device is
operating
○ fl ashing green: water needs to be
changed
○ fl ashing red: battery needs to be
charged
○ fl ashing alternately red and green:
water needs to be changed and
battery needs to be charged
• The device has a dirty water sensor.
After the water tank is fi lled or the
water is changed, this measures the
particle density in the liquid. The dirty
water sensor uses this output value to
determine when the water needs to
be changed.
Please Note: The dirty water sensor
is reset once the battery has been
charged or once the control lamp has
displayed a water change and the
device has then been switched off.
22.04.2020 11:21:04 22.04.2020 11:21:04